Renforth Resources Inc. releases the following information for wholly owned Parbec gold deposit and wholly owned Surimeau nickel/copper/zinc project. Renforth would like to inform shareholders of the receipt of partial assays for PAR-21-131, an 87m long hole which was successfully drilled as a twin of PAR-93-54. PAR-21-131 intersected 9.55m of 4.42 g/t gold, with a sub-interval of 3.9m grading 10.31 g/t gold, commencing at 48.45m down the hole, a vertical depth of approximately 40m, within the area of the Whittle open pit which accompanies the May 2020 Resource Estimate for Parbec. PAR-93-54 intersected 7.25m of 9.5 g/t gold between 50.66 and 57.91m down the hole, the PAR-21-131 interval lines up with the PAR-93-54 interval. Subsequent to the resource estimate there has been 15,569m of drilling completed at Parbec, including a certain number of twinned holes designed to validate the inclusion of assay data produced in approximately 13,000m of drilling which took place between 1986 and 1993 and was not included in the May 2020 Resource Estimate. With this interval from PAR-21-131 the Top Ten Intervals from the 2020/21 drill program at Parbec is updated to the following, available on website along with a recap of all of the highlight drill results released to date for this program. Renforth informs shareholders that have changed June exploration focus from Malartic West copper and silver discovery to wholly owned Surimeau District battery metals project, with approximately 1,000m of drilling and field prospecting on this largely unexplored 260 km 2 property, hosting nickel, copper and zinc mineralization on surface and in drill core, contiguous to the Canadian Malartic Mine property in NW Quebec. Assay results from the 3456m, 15 drill hole program, completed in April 2021, are largely still outstanding. Management is confident proceeding with this drill program based upon the visual results of Spring 2021 where sulphides were observed, to varying degrees, in each hole drilled over the 2.2 kms. of strike within the approximately 5km long Victoria West target at Surimeau. The drill, which will arrive later this week, will make use of previously permitted drill set ups, drilling steeper undercuts of prior holes and, if accessible, the two western cut pads which were not drilled in the Spring 2021 program. The drill permit required to proceed at Malartic West, in an area which has been entirely logged, has been delayed, outside of Renforth's control.