Walker River Resources Corp. provide an update on its reverse circulation ("RC") drill program at the 100% owned Lapon Gold Project located approximately 60 kilometres southeast of Yerington, Nevada. A total of seventeen (17) drill holes were completed at the Lapon Gold Project. Sample preparation of the drill holes has been finalized, with over 1300 samples submitted to certified laboratory facilities in Sparks, NV. Seven (7) RC drill holes were drilled at the Pikes Peak portion of the Lapon Gold Project. Of these, two were abandoned in poor rock conditions consisting of intense shearing, fracturing and the abundance of water encountered within the holes. These RC drill holes represent the first recorded modern drilling at Pikes Peak. This initial drill program was designed for geological purposes to determine rock types, geometry, structure, and the potential for gold and copper
mineralization. Significant historical mining activities are present at Pikes Peak (shafts, adits, mill) in a copper -- gold environment. Previous sampling (see news release 9/04/2019) by Walker returned values of 9 g/t Gold and 2.2% Copper from bedrock. Geological mapping and surveying also revealed the presence of quartz monozonite porphyry, very significant for the emplacement of copper gold mineralization in Nevada and elsewhere. The historical underground workings at the Pikes Peak Project are currently inaccessible, due to cave-ins and unstable ground. Ten (10) holes were carried out at the Lapon Canyon portion of the Lapon Gold Project. Primarily on continued drill exploration at the Hotspot area, located 200 meters above and 250 meters on strike SE of the historic mine workings, and high - grade drilling intercepts from Walker's previous drilling (see Walker's previous news release from 2016 to 2022). Significant drill results were encountered at the Hotspot zone, including 7.62 g/t Au over 48.8 m in LC 21-80, 5.68 g/t Au over 60.9 m in LC 21-81 and 1.84 g/t Au over 122 m in LC 21-84, (see news release 03/31/2022) among other significant drill results from this specific area of the Project. The Hotspot Zone appears to be flat lying (sub horizontal to horizontal), analogous to Basin and Range thrust faulting. For these reasons, drilling appears it can be carried out in different directions (azimuth) from the same drill pad, with multiple holes drilled from one drill set up, often in a fan shaped pattern. The current drill program was designed to test the feasibility of drilling multiple holes from the same drill set up, for systematic drilling on section. Drilling was successful in this regard, with the completion of 10 holes from three drill pads. This, combined with the geometry of the mineralized zone, will allow Walker to carry out systematic drilling on section with pads placed at every 30 meters or so, and up to five (5) drill holes per drill pad. The Hot Spot area's topography and steepness of the mountain is less severe, allowing for simpler, faster drill access construction, set up and drilling. The mineralization is not visible at surface, as it is overlain by approximately 3 meters of loose colluvium, making drill road access and pad construction quicker at less cost. Additional drill access road and pad construction has been completed for future drill programs.